5/30/2023 0 Comments Wave multitrack![]() ![]() The question is simply, wouldn't it be nicer if DIGICheck tools could pickup the audio signal directly from HW Input channels instead of having to use loopback ? Maybe somehow technically possible, maybe as future extension of TM/DIGICheck ? So as can be seen, never too bad to have a few unused channels on an interface for such routing / loopback purposes To be able to capture the Durec Playback of MA59+60 with DIGICheck Tools on HW Inputs MA 63+64. I need to route HW inputs MA 59+60 to HW Outputs MA 63+64 and then use loopback there I got it to work by using loopback of MAIN OUT (AES).Īlthough I see no signal on the corresponding HW Input (AES) I can use in Totalyser the HW inputs AES L and R the two Mic recordings of guitar (MA 59+60) Now I would like to see the effects of EQ adjustments while DURec playback of MA 59-62, i.e. (I am doing this to be able to use a different Mix and EQ settings between DURec recording and playback). I am just playing back the recorded multitrack file with DURec, all is very nice (4 mono, 1 stereo channel).ĭURec playback I am performing through the not used HW Input channels MADI 59-64 To route those inputs 1st to a free HW Input/Output pair of channels and using then loopback. To be able to visualize DURec Playback via HW Inputs in DIGIcheck without having There is maybe one additional point for DIGICheck, not sure whether possible. ![]() That would be extremely nice, many thanks for looking into this :-) ![]()
0 Comments
Leave a Reply. |